Atop-technology SW550X User manual Manuel d'utilisateur télécharger pdf (Page 73)

Atop Industrial Wireless Serial Device Server Series

SW550X

User Manual V 1.1

4.2.2 TCP Server Application: Enable RFC 2217

The underlying protocol of Virtual COM is based on RFC 2217, the Telnet COM Control Option.

Therefore, it is possible to use RFC 2217 with SW550X in the TCP Server mode. To do so,

refer to Sec. 4.2.1 to enable Virtual COM, so that SW550X becomes aware of the commands.

Note that there is no need to configure Virtual COM on the Operating System because Virtual

COM ports would not be used.

4.2.3 TCP Client Application: Enable Virtual COM

It is also possible to run VCOM in TCP Client mode, Fig. 4. 12. It is usually easier to use Virtual

COM in the Client mode if SW550X uses dynamic IP (DHCP) because setting a static IP

address in Virtual COM’s Control Panel in the Operating System is not possible.

Fig. 4. 12

 Follow Sec. 4.1.2 to configure SW550X in TCP Client mode properly.

 Click on the dropdown box of the Application option and switch to “Virtual COM” to

enabled Virtual COM application in SW550X.

 Scroll to the bottom of the page and click on “Save & Apply” button to save the

changes.

 Configure Virtual COM in the Operating System. For Windows, refer to Chapter 5.

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 124 125

Pas de commentaire

Atop-technology SW550X User manual Manuel d'utilisateur Page 73